1 |
|
Water tank: |
| |
A |
Number and capacity: 3 tanks totaling 300 gallons (1136 liters) |
| |
B |
Fiberglass construction using vinylester resin and FDA approved gelcoat on inside of tank construction per plan. |
| |
C |
Inspection plates: Appropriately positioned for access |
| |
D |
Two sight gauges to monitor water level in upper tanks |
| |
E |
Each tank air tested: 4 pounds per sq. inch |
| |
|
|
| 2 |
|
Fuel tank: |
| |
A |
Number and capacity: 2 main tanks totaling 1200 gallons(4542 liters) with one centerline aluminum 'Day Tank' at 40 gallons which will gravity feed from main tanks |
| |
B |
Fiberglass construction with vinylester resin per plan #43-00 |
| |
C |
Inspection plates appropriately positioned for interior access by average size man. Each internal baffle with a removable panel to allow access to entire interior of both fuel tanks |
| |
D |
Fuel system to include an aluminum supply reservoir, which feeds by gravity from both fuel tanks. Top part of supply reservoir to hold approximately 2 gallons(7.5 liters) and fitted with a sight gauge with a one gallon(3.5 liters) range and a 10th gallon (.4 liters) marks for fuel consumption checks (supply lines are turned off and fuel is consumed from reservoir). Bottom part of reservoir to be approximately 40 gallons(151 liters) fitted with a drain off at the bottom of the reservoir for water purging and with a water sensor - illuminating a light in wheel house if excessive water is present. Reservoir fitted with four draw spigot valves for main, generator, wing engine and spare - mounted at lower level of reservoir, but above water sensing probe. All returns from main, wing and generator plumbed into reservoir |
| |
E |
Sight gauges provided for both fuel tanks and are vented into the main vent system for each tank |
| |
F |
Each tank to be air tested to 4 pounds per sq. inch |
| |
G |
Baffles on 24"(610mm) centers |
| |
H |
A transfer manifold and Walboro (FRB13-2) fuel pump with timer switch and Racor 900 fuel filter which can transfer fuel from one tank to another and scrub fuel while transferring. Transfer is also used to fill top part of supply reservoir for consumption testing when main fuel tank level drops below the level of the testing part of the reservoir |
| |
|
|
| 3 |
|
Fuel pipe and hose: |
| |
A |
Supply lines from tanks to supply reservoir are 3/4"(19mm) ID with Aeroquip brand fuel hose and swaged brass fittings |
| |
B |
Fuel line from supply reservoir to main engine filter is 3/4"(19mm) ID with Aeroquip brand fuel hose and swaged brass fittings |
| |
C |
Fuel lines from supply reservoir to optional generator and wing engine to be 1/2"(13mm) ID with Aeroquip brand fuel hose and swaged fittings |
| |
D |
Vent lines to be fuel certified, reinforced hose 3/4"(19mm) ID |
| |
E |
Install fuel fills on side decks - as on N40 with vent lines inboard |
| |
|
|
| 4 |
|
Water hoses: |
| |
A |
Cold water 1/2"(13mm) diameter Whale tubing system or equivalent with all Whale fittings |
| |
B |
Hot water 1/2"(13mm) diameter Whale tubing with all Whale fittings |
| |
C |
Sea water hoses: Trident reinforced rubber certified for marine use and provided with double stainless steel clamps below the water line |
| |
|
|
| 5 |
|
Water heater: Seaward #S1100 or Attwood (11 gallon{42 liters}) 110 volt and heat exchanger operation |
| |
|
|
| 6 |
|
Thru hulls: Bronze body, stainless steel balls and Teflon seats |
| |
A |
Grounding wire: #6 gauge green wire |
| |
B |
Each thru hull to have a clearly visible tag indicating its function |
| |
|
|
| 7 |
|
Fresh water pressure pump #VSD31755-0000 Jabsco Sensor Max |
| |
|
|
| 8 |
|
Plumbing fixtures: |
| |
A |
Head sinks: Sea-Land #1620 oval color white x 2 |
| |
B |
Galley sink: double stainless steel Polar # 102110 with 3"(76mm) drain fittings |
| |
C |
Head faucets: Grohe model #33170 000 chrome |
| |
D |
Galley faucets: Grohe model #33939 1B0 chrome with black |
| |
E |
Shower fixtures: Grohe chrome #28.049 handle |
| |
|
#28.786 soap tray |
| |
|
#28.820 24"(61cm) shower bar |
| |
|
#28.151 non-metallic hose |
| |
|
#34.436 thermostat valve |
| |
|
|
| 9 |
|
Gray water tank: |
| |
|
Galley sink, head sinks, shower sumps and washing machine drain to 50 gallon(189 liters) sump tank. Each drain to have an appropriate water trap to control odors. Sump to include Sealand Tank Watch 4 level indicator and a Sealand T12 waste pump fitted with an Ultra Jr. pump switch and auto/manual control panel. Whale/Henderson #BP0527 hand operated diaphragm bilge pump to be installed in line with Sealand T12 for manual pumping of gray water tank per design #43-000 |
| |
|
|
| 10 |
|
Bilge pumps: |
| |
A |
Electric: Par 34600-00 diaphragm 10.8 GPM with Ultra switch auto switch |
| |
B |
Manual: Edson model #638AL operable from main salon |
| |
C |
High water bilge pump Rule 3700 GPH (55S) - mounted in bilge above normal bilge water height including Ultra Sr. pump switch and Ultra bilge alarm |
| |
|
|
| 11 |
|
Toilets: |
| |
A |
Tecma Silence Plus head in owners stateroom head |
| |
B |
Tecma Silence Plus head in guest stateroom head |
| |
C |
Head fitted with a Par #45510-0000 Y valve allowing sewage to be pumped overboard or into holding tank |
| |
D |
Holding tank: Fiberglass |
| |
E |
Holding tank pump: Whale hand operated diaphragm |
| |
F |
Holding tank fitted with a deck pump out |
| |
G |
Sealand Tank Watch 4 monitoring system with tank master |
| |
|
|
| 12 |
|
All hoses throughout boat to be Trident brand with CE approval - where practical |
| |
|
|
| 13 |
|
LPG system: System to comply with all ABYC recommendations |
| |
A |
Two (2) Worthington #D200145WCI 20lb. LPG aluminum bottles |
| |
B |
Trident LPG control panel and detection system #1300-7715. Sniffer behind stove/oven and in LPG locker |
| |
C |
Two stage regulator #12301411 |
| |
D |
Trident 'Pig Tail' hoses x 2 #1014140120 |
| |
E |
All necessary pipe fittings and adapters |
| |
F |
Trident LPG hose to suit |
