| Water Tank |
| Number and capacity: Two (2) totaling 500 gallons (1,893 liters) |
| Material: Integral fiberglass with vinylester resin and FDA approved gel coated interior |
| Inspection plates: Appropriately positioned and sized for access |
| Tank air tested to 4.5 lbs. (2.04 kg) per sq. inch |
| Tank has "Wema" level gauge |
| Tank baffles is spaced on 24" (61 cm) centers as shown in design - and removable for interior access |
| Exterior of tank finished in blue gel coat |
| Tank complies with ABYC section H-23 for potable water systems for use on boats |
| Cleanliness: Tank interior surfaces are thoroughly vacuumed and wiped down prior to final closure |
|
| Fuel Tanks |
| Number and capacity: Four (4) totaling 3,230 gallons (12,226 liters) with one centerline aluminum “Supply Reservoir” at 80 gallons (302.83 liters) |
| FRP construction from male molds using Vinylester resin. To comply with all ABYC codes for diesel fuel tanks. Tanks to be coated with fire retardant gelcoat on outside to comply with ABYC section H-33.20 for fire resistance |
| Inspection plates appropriately positioned for interior access by average size man. Plates to be fitted with labels that contain all information as stated in ABYC section H-33.16.3. Each internal baffle to have a removable panel to allow access to entire interior of all fuel tanks |
| Fuel system to include a powder coated aluminum supply reservoir, which feeds by gravity from all fuel tanks. Bottom part of reservoir to be fitted with a drain valve at the bottom of the reservoir for water and debris purging and with a water sensor – illuminating a light and audible alarm in wheelhouse if excessive water is present. Reservoir fitted with five (5) draw spigots for main, two (2) generators, wing engine and spare - mounted at lower level of reservoir but above water sensing probe. All returns from main, wing and generator plumbed into reservoir via a return manifold |
| Sight gauges provided for two (2) engine room fuel tanks. Forward tanks share one (1) sight gauge located in utility room |
| Each tank to be air tested to 4.5 lbs (2.04 kg) per square inch |
| Provide baffles on 24" (61 cm) centers |
| Transfer manifold and 24 volt DC Orberdorfer gear pump 3.5 gallons (11.36 liters) per minute fuel pump with timer switch and Racor 1000 fuel filter with 10 micron element which can transfer fuel from one tank to another and scrub fuel while transferring. Transfer is also used to fill top part of supply reservoir for consumption testing when main fuel tank level drops below the level of the testing part of the reservoir |
| Exterior of tanks finished in red gel coat |
| Cleanliness: tank interior surfaces to be vacuumed and wiped clean before final closure |
| Each tank to have two (2) 1” (2.5 cm) I.D. vent lines |
| Each tank to have separate 2” (5.08 cm) I.D. fill pipe located a minimum distance of 18” (45.7 cm) from any ventilation openings |
| All hardware that comes in contact with fuel to be bonded into the 24 volt DC ground system |
|
| Fuel Pipe and Hose |
| Supply lines from tanks to supply reservoir are 1-1/2” (3.8 cm) I.D .with Aeroquip brand fuel hose and swaged brass fittings |
| Fuel line from supply reservoir to main engine filter is 3/4" (1.9 cm) I.D. with Aeroquip brand fuel hose and swaged brass fittings |
| Fuel lines from supply reservoir to optional generator and wing engine to be 1/2” (1.27 cm) I.D. with Aeroquip brand fuel hose and swaged fittings |
| Vent lines to be fuel certified, reinforced hose 1” (2.5 cm) I.D. |
|
| Water Hoses |
| Cold water: Hose from water tanks to water pump and to accumulator to be 1" (2.5 cm) diameter reinforced and approved for potable water; Branch lines to be 1/2" (1.27 cm) Shurflo "Shurpex" brand semi rigid tubing with quick connect fittings (blue) |
| Hot water: Reinforced 1/2" (1.27 cm) Shurflo "Shurpex" brand semi rigid tubing with quick connect fittings (red) |
| Sea water hoses: Reinforced for marine use and provided with double stainless steel clamps below the water line |
| All hoses used shall meet the requirements for service as set out by ABYC for the system intended |
|
| Hot Water Heater System: |
| Heater: RHEEM Vanguard low boy, 47 gallon (178 liters) 240 volt AC elements for quick recovery |
|
| Thru Hulls: Bronze body, stainless steel balls and Teflon seats |
| Grounding wire: # 6 gauge green wire |
| Each thru hull to have a clearly visible tag indicating use |
| Each thru hull to be easily accessible |
|
| Fresh Water System: |
| Main Pump: Headhunter Mach 5 # M5-115 - 120 volt with pressure regulator and Groco WSA-1000 strainer on pump inlet |
| Groco # PST5 accumulator tank with pressure gauge |
| Hose from water tanks to water pumps and to accumulator to be 1" (2.5 cm) diameter reinforced and approved for potable water |
| Back up pump: Headhunter "X-Caliber" 12-24 volt DC pump # XR-124 |
| Filter: US water filter housing with a 5 micron sediment filter installed downstream of fresh water discharge manifold |
| Pump selection manifolds x two (2): Pump inlet and discharge manifolds made of stainless steel standard pipe. Supply manifold furnished with isolation ball valves from each fresh water tank, to each fresh water pump, and from the water maker. Discharge manifold furnished with isolation valves from each pump |
|
| Plumbing fixtures |
| Head sinks: Owner's, guest, and day head. Under counter mount- HCG L 337 White oval sink. (3 total) |
| Galley sink: Double stainless steel Kohler # K-3351 |
| Head faucets: Grohe # 33413 chrome (3 total) |
| Galley, flybridge and engine room sink faucets: Grohe # 33939 1 B0 chrome/black (3 total) |
| Aft deck faucet is folding faucet. Scandvik # MR4550 |
| Engine room sink, flybridge and aft deck sink: local made stainless steel |
| Shower fixtures: Two (2) All Grohe # 28179 handle, # 28786 soap dish, # 28.820 24" (61 cm) shower bar, # 28.151 hose, # 34.436 thermostat valve |
|
| Bilge Pumps: |
| Electric: Four (4) Par Jabsco 34600-0010 24 volt 10.8 gallons (40.9 liters) per minute. Diaphragm 1" (2.5 cm) diameter ports, with "Ultra Senior" 24 volt auto float switch # UPS-01-24/32. One (1) in each water tight compartment |
| Manual: Four (4) Edson # 638AL. One (1) in each water tight compartment |
| Hydraulic drive emergency pump: One (1) "Pacer" 180 gallons (681.4 liters) per minute plumbed to all water tight compartments. Manifold for emergency pump to be located in easily accessible location |
| High water bilge pump system - engine room: Rule 16A, 3700 gallons (14,006 liters) per hour, 24 volts AC, Rule # 33AL high wate bilge alarm, and "Ultra Senior" bilge switch |
| High water bilge alarm panel - pilothouse per PAE design. High water bilge sense will come from standard. Ultra Senior in each bilge compartment. Visual and audio alarm panel in pilot house |
|
| Toilets and Holding Tank System: |
| All toilets to be Tecma Silence Plus (white). (3 total) |
| Water supply to toilets to be fresh water only |
| Holding Tank: One (1) Integral FRP with vinylester resin 150 gallon (567.8 liter) holding tank |
| Use only PVC pipe or Sealand "Odor Safe" hose |
| Holding tank overboard pumps: Edson "Bone Dry" # 120ELB 20 gallons (75.71 liters) per minute, 120 volt AC electric and Edson "Bone Dry" # 557BR 20 gallons (75.7 liters) per minute manual pump per drawing |
| Holding tank vent to use Sealand # 310002 vent filter |
| Deck fitting for portable evacuation facility |
| Holding Tank Level Monitor: Sealand 24 volt Tank Watch 4 panel and cap with vent, 45" (114.3 cm) probes # 600115, including universal flange 3" (7.6 cm) NPT with gasket and stainless steel hardware, 24 volt "Do Not Flush" status panel # 700024 and shut down relay # 342490 warning system at each toilet |
|
| Fresh water outlets on the foredeck, aft deck, boat deck and one (1) in engine room using stainless steel "Scandvik" spigot |
|
| Gray Water System: |
| Tank: One (1) Integral FRP 150 gallon (567.8 liter) tank. All sinks, showers, and air conditioning condensate to drain to tank. All drains to have "P" traps and sloped downhill run to tank. Exception: engine room sink drain will be pumped to gray water tank . Tank equipped with electric and manual discharge pumps, level switch for pump starting, and level monitor system |
| Electric Discharge Pump: Sealand T24 discharge pump 24 volt with auto/manual switching. Pump inlet to draw within 1" (2.5 cm) of the absolute bottom of the tank. Pump to discharge overboard through anti siphon loop |
| Level Switch: ULTRA Junior pump switch (float type) Model WPS-02-24/32, 24 volt to auto start and stop the gray water pump in the AUTO mode. In AUTO mode, switch to start pump at 2-1/2" (6.4 cm) depth and stop pump at 1" (2.5 cm) depth |
| Level Monitor System: Headhunter 24 volt tank sentry panel WPS-1500 |
| Manual back up pump: Edson # 638AL |
| Fitting provided for deck pump out. |
| "Hepvo" odor valve fitted on grey water system |
|
| "Scandvik" aft deck shower installed on transom per PAE design |
|
| LPG system with two (2) 30 lb. (13.6 kg) aluminum LPG bottles with "Trident" two stage regulator and "Xintex" monitor panel # XINTX#S-2A with two (2) sniffers located per PAE design |
|
| Raw water supply to various systems: Individual raw water inlet thru hulls per item requiring raw water |
| Wing engine, generator(s), water maker intake and air conditioning |
| Each inlet to have Groco strainer |
| Each thru hull on the exterior to have grate installed to keep debris out |
|
| Oil Change System |
| System utilizes a 120 volt AC Orberdorfer gear pump, 3.5 gallons (13.25 liters) per minute to drain and fill engine lube oil from/to crankcases of main, wing, and generator(s) engines. Pump is controlled by a three (3) position switch mounted at pump location. Switch positions to be labeled "ENGINE OIL DRAIN", "OFF", "ENGINE OIL FILL" |
| Oil change manifold per PAE design. Manifold, pump and control switch to be located in an accessible and comfortable location. Engine side of manifold to include isolation valves for each engine. Pump discharge/fill side to include a hose of suitable length for drawing from and discharging to a locally placed container |
|
| Engine room sink sump system |
| System to be self contained with external whale gulper pump and Ultra senior float switch consisting of sump enclosure, sump pump and float switch |
| Sump pump to discharge to the gray water tank. |
