| 1. |
|
Kobelt Hydraulic Steering System - 35 degree Rudder Deflection, Single Station (wheel house) per quote no. SQ-15872 |
| |
A. |
Helm Pump x 1: Model #7005-AL long shaft |
| |
B. |
Cylinders: 1 x Model # 7085-B16 balanced cylinder with 3.5"Bore with 16" stroke and 1 x Model# 7085-SB16 servo cylinder with 3.5" bore and 16" stroke |
| |
C. |
Safety and Bypass Valve: Model #7020 |
| |
D. |
Double arm for 7080 cylinder Arm: Model #7084-T |
| |
E. |
Single Arm Tiller Arm: Model #7084-S |
| |
F. |
Two (2) rod ends Model #7085-0004 |
| |
G. |
7085 tie bar ends with nut (2) Model # 7085-1004 |
| |
H. |
Filler Tank: Model #7002-A |
| |
I. |
Rudder feedback unit Model #7168-P |
| |
J. |
Master rudder angle indicator Model #7175-BMA |
| |
K. |
Rudder angle indicator Model #7175-BSA |
| |
L. |
Transfer box : 1 station +AP Model # 7173-TX2 |
| |
M. |
Jog lever for Five(5) stations Model # 7170-A1 |
| |
N. |
Single solenoid valve base (no sol) Model #7144 |
| |
O. |
Solenoid valve Model #7148-SOL24V |
| |
P |
Power pack is (2) Eaton model #04223-LH 7/8-13 tooth 2 bolt SAE "B" pad, PC pumps including reservoir, tank top return filter, low level/high temperature switch and pressure gauge. Cooling of hydraulic oil is done through two heat exchangers that are fed with raw water from a gear driven pump on each main engine. |
| |
Q. |
Flow control model #3005 |
| |
R. |
Flow control model #3005-B |
| |
S. |
Auto pilot interface #7085-SAP-24 |
| |
T. |
Non drain back valve #7143 |
| |
U. |
Manual |
| |
|
|
| 2. |
|
Hydraulic lines: Seamless copper tubing 5/8" I.D. with reinforced rubber hydraulic lines to the hydraulic rams and helm pump. |
| |
|
|
| 3. |
|
Steering wheel x 1: 30" stainless steel destroyer type in wheel house |
| |
|
|
| 4. |
|
Emergency tiller: To attach to top of stbd. rudderpost and stow in Lazarette - fabricated of stainless steel |
| |
|
|
