Electrical panel set consisting of the following: |
Electrical AC/DC panel |
One (1) parallel switch for emergency engine/house battery paralleling |
Engine battery shut off switch and panel |
|
Shore power inletand AC system per design |
Marinco#303SSEL-B stainless steel 30 amp 2 pole 3 wire |
120 volt 60 Hz |
Interior outlets per drawing |
All galley and head outlets to be GFCI protected |
|
Battery and DC system per design |
Three (3) 255+ AH (8D) Lifeline batteries for house appliances (765 amps) and one (1) additional 4D for engine starting. The engine starting battery is isolated from the house batteries, which prevents the inadvertent discharge of the engine starting battery. Main engine has dual alternators - 140 amp large case for house and a 90 amp for engine start battery charging. Parallel switches provide for emergency engine starting or to parallel alternators in case of an alternator failure |
Each battery secured with stainless steel tie down beams |
|
Battery cable: to be '00' for general battery leads with '0000' for starting and optional bow thruster |
Positive lead to be red |
Negative to be black |
|
All wiring used throughout boat to be color coded - all wire supplied by factory to be tinned wire |
|
Conduits for future installations: |
PVC from mast step to pilot house, these conduits are to be as large as possible |
PVC from engine room to pilot house, these conduits are to be as large as possible |
|
Electrolytic control: |
All thru hulls to be bonded together with a #6 green wire and tied into the 12 volt DC ground system |
All hardware mounted below waterline i.e. stuffing box, stern bearing housing, rudder shoe, rudder frame, rudder stuffing box to be grounded into 12 volt DC ground system |
Zinc plates - Two (2) 2-1/2" x 5-3/4" (6 cm x 15 cm) zinc plates tied into the 12 volt DC ground system |
|
AC Generator (optional) |
Foundation to be provided within the engine room to accommodate up to a 12 kW generator |
Electrical panel to accommodate AC ship's power |
|
Heart 3000-watt inverter/battery charger included with remote panel at wheel house |
|
TV/phone inletMarinco #PH6592TV-SS. Wires run to predetermined locations in boat |