Welcome to Nordhavn.com - Power Thats Oceans Apart
   
 
side_menu



PLUMBING SYSTEM

 

Water tanks:

Number and capacity: Two (2) tanks totaling 340 gallons (1287 Liters)

Water tanks to be connected with balancing hose. Balancing hose shall have one isolation ball valve installed

Fiberglass construction using vinyl ester resin and FDA approved gel coat on inside of tank construction per plan

Inspection plates: Appropriately positioned for access

WEMA gauge to inspect level of water tanks. Gauge located at the helm

Wema.jpg

Each tank air tested: 4.5PSI (31.02kPa)

Tank baffles to be spaced on 24" (61cm) centers.

Exterior of tank to be finished in blue gel coat

Tanks to comply with ABYC section H-23 for potable water systems on boats

Cleanliness: Tank interior surfaces to be thoroughly vacuumed and wiped down before final closure

 

Fuel tank:

Number and capacity: One (1) main tank totaling 1100 gallons (4164 Liters)

FRP construction from male molds using vinyl ester resin. To comply with all ABYC codes for diesel fuel tanks. Tanks to be coated with fire retardant gel coat on outside to comply with ABYC section H-33.20 for fire resistance

Inspection plates appropriately positioned for interior access by average size man.  Each internal baffle with a removable panel to allow access to entire interior of both fuel tanks

Fuel system to include supply manifold, which feeds by gravity from the fuel tank. Bottom portion of main fuel tank to be fitted with a drain and valve for water purging and with a water sensor - illuminating a light at helm station if excessive water is present.  Manifold fitted with four draw spigot valves for mains, generator, and spare.  All returns from mains, and generator plumbed into main tank via a return manifold

Sight gauge provided for fuel tank with Apollo self closing valve at bottom.

Tank to be air tested to 4.5PSI (31.02kPa)

Tank baffles to be spaced on 24" (61cm) centers.

 

Cleanliness: Tank interior surfaces to be thoroughly vacuumed and wiped down before final closure

All hardware that comes in contact with fuel to be bonded into the 24 volt DC ground system

Fuel tank supply valves to be located under a floor hatch in the master cabin, this will eliminate all bulky electric solenoid valves

 

Fuel pipe and hose:

Supply line from tank to supply manifold is 3/4" (1.9 cm) I.D. with Aeroquip brand fuel hose and swaged brass fittings

Aeroquip Fuel Hose.jpg

Fuel line from supply manifold to main engine filters is 3/4" (1.9 cm) I.D. with Aeroquip brand fuel hose and swaged brass fittings

Fuel lines from supply manifold to generator to be 1/2" (1.27 cm) I.D. with Aeroquip brand fuel hose and swaged fittings

Install two (2) fuel tank vent lines. Vent lines to be fuel certified, Trident #327 reinforced hose 1" (2.54 cm) I.D.

nstall 2" fuel fill on aft deck, fuel fill hose to be Trident #327

Trident 327 Fuel Hose.PNG

Line from return manifold to tank to be 3/4" (1.9cm) I.D. with Aeroquip brand fuel hose and swaged brass fittings

 

Water hoses:

Cold water 1/2" (1.27 cm) diameter Whale tubing system or equivalent with all Whale fittings

Hot water 1/2" (1.27 cm) diameter Whale tubing system or equivalent with all Whale fittings

Uponor Hose.jpg

 

Sea water hoses: Trident reinforced rubber certified for marine use and provided with double stainless steel clamps below the water line

Fresh water fill hose to be Trident #148

Trident 148 Water Fill Hose.PNG

 

Water heater: Seaward #S1100 or Attwood (11 gallon ) (42 liters) 110 volt and heat exchanger operation

     Seaward SW1100 Water Heater.jpg

Thru hulls:  Bronze body with 316 stainless steel balls and Teflon seats

Grounding wire: #6 gauge green wire

Each thru hull to have a clearly visible tag indicating its function

 

Fresh water pressure pump:  120VAC Headhunter Mach 5  x one (1)

       Headhunter Mach 5.jpg

Install one (1) Groco #WSB-1000 strainer on the inlet side of the fresh water pump

Groco WSB1000.jpg

Install one (1) Groco #PST1 Accumulator tank on the discharge side of the fresh water pump

   Groco PST1 Accumulater tank.jpg

 

 

 

 

Install one (1) US Filter  5 micron sediment filter on the discharge side of the fresh water pump

US Filter 5 Micron.jpg

 

Plumbing fixtures:

Head sinks: Toto "Legato" under counter lavatory, model no. #LT624G, color white x two (2)

Toto Legato Sink.jpg

Galley sink: double stainless steel with 3" (7.6 cm) drain fittings

Head faucets: Grohe Allure model #19387 000  wall mount chrome x 2

Grohe Allure 19387-000.jpg

 

 

Galley faucet: Grohe "Minta" model #32 319 000 Starlite Chrome

Grohe Minta 32319-000-.jpg

 

Shower fixtures: Grohe  Euphoria Cube + Stick Shower Set model no. #27891 000

Grohe Euphoria Cube and Stick 27891000.gif Grohe Allure 19375000.gif Grohe valve 35015000.gif

 

 

Bilge pumps:

Rule 3700 gallons (14,006 Liters) per hour (55S) 24vdc - including Ultra Sr. pump switch #PS-01 24/32v

Rule 3700.PNG

 

Manual: Edson model #638AL x one (1)

Edson 638AL.gif

High water bilge pump Rule 3700 gallons (14,006 Liters) per hour (55S) 24vdc - mounted in bilge above normal bilge water height including Ultra Sr. pump switch and Ultra bilge alarm both visual and audio located at the helm

Ultra Senior.jpg

Toilets:

Tecma Silence Plus head in owners stateroom head; fresh water flush; white in color

Tecma Silence Plus.jpg

Tecma Silence Plus head in guest stateroom head; fresh water flush; white in color

Install Tecma 2 button marine wall switch panel in each head

Tecma 2 button panel.PNG

Heads fitted with a Par #45510-0000 “Y” valve allowing sewage to be pumped overboard or into 80 gallon holding tank

Par 44510-000 valve.jpg

 

Holding tank: Fiberglass w/ vent 80 gallons total

 

Holding tank pump: Sealand T-24, 24 volt plus Whale/Henderson #BP0527 hand operated diaphragm pumps to be installed. Per PAE design

Sealand T24.jpg

Holding tank fitted with a deck pump out

Sealand Tank Watch 4 monitoring system with tank master

Sealand Tank Watch 4.jpg

Use only PVC pipe and Trident #102 sanitation hose

Trident 102 Sanitation Hose.PNG

 

Cleanliness: Tank interior surfaces to be thoroughly vacuumed and wiped down before final closure

 

Gray Water Tank:

Galley sink, head sinks, shower sumps, washing machine and dishwasher drain to 80 gallon (303 Liter) sump tank. Each drain to have an appropriate water trap to control odors. Tank to include Sealand Tank Watch 4 level indicator and a Sealand T24 Waste Pump fitted with an Ultra Jr. pump switch and auto/manual control panel and Hepvo valve at intake to tank. Whale/Henderson #BP0527 hand operated diaphragm bilge pump in addition to the Sealand T24 for manual pumping of gray water tank per PAE design

 

Gray water hoses to be Trident #140

Trident 140 Gray Water Hose.PNG

Cleanliness: Tank interior surfaces to be thoroughly vacuumed and wiped down before final closure

 

All hoses throughout boat to be Trident brand with CE approval - where practical

 

Air conditioning Cruisair 230v 60HZ/single phase

Self contained units for each area. Two for salon/galley, one for each stateroom. Five (5) total

Salon/Galley 2 x #STO16C (Located in F/B coaming with return air grills in overhead)

Owner's cabin 1 x STO12C

Port guest cabin 1 x STO8C

Fwd. guest cabin 1 x STO12C

1 x #PS1500BX raw water pump

1 x #PR8X-5C control


*Specifications subject to change without notice and at the discretion of designers and builders.
**Dimensions are subject to change with Buyer’s selected options and personal effects which may add to displacement and increase both draft and waterline length

Last updated: 7/14/14

 


Nordhavn Fleet

40

43

52

56MS

59CP

60

63

64

68

72

75EYF

76

78

96

120