Kobelt Hydraulic Steering System - 35 degree rudder deflection, single station (wheel house) per quote no. SQ-15872

One (1) helm pump: Model #7005-AL long shaft

Cylinders: One (1) model # 7085-B16 balanced cylinder with 3-1/2" (8.9 cm) Bore with 16" (40.6 cm) stroke and one (1) model# 7085-SB16 servo cylinder with 3-1/2" (8.9 cm) bore and 16" (40.6 cm) stroke

Safety and bypass valve: Model #7020

Double arm for 7080 cylinder arm: Model #7084-T

Single arm tiller arm: Model #7084-S

Two (2) rod ends model #7085-0004

Two (2) 7085 tie bar ends with nut model #7085-1004

Filler tank: Model #7002-A

Rudder feedback unit model #7168-P

Master rudder angle indicator model #7175-BMA

Rudder angle indicator model #7175-BSA

Transfer box : One (1) station +AP model # 7173-TX2

Jog lever for five (5) stations model # 7170-A1

Single solenoid valve base (no sol) model #7144

Solenoid valve model #7148-SOL24V

Power pack is two (2) Eaton model #04223-LH 7/8-13 tooth 2 bolt SAE "B" pad, PC pumps including reservoir, tank top return filter, low level/high temperature switch and pressure gauge. Cooling of hydraulic oil is done through two heat exchangers that are fed with raw water from a gear driven pump on each main engine

Flow control model #3005

Flow control model #3005-B

Auto pilot interface #7085-SAP-24

Non drain back valve #7143

Owner's manual

Hydraulic lines: Seamless copper tubing 5/8" (16 mm) I.D. with reinforced rubber hydraulic lines to the hydraulic rams and helm pump

Steering wheel: 30" (11.8 cm) stainless steel destroyer type in wheel house x one (1)

Emergency tiller: To attach to top of starboard rudderpost and stow in lazarette - fabricated of stainless steel