All Horizontal Surfaces on Deck to have a diamond pattern non skid as shown in deck plan - standard non skid to be a contrasting color to deck parameter

Stainless 316 Handrails 1-1/4" (3.18 cm) electro polished bases as shown on drawing with the following additional:

N76 transom hand rails

N76 style hand rails along port and starboard side deck coamings

N76 style rail on underside of aft deck overhang

Rail around F/B sink console

Nine (9) 316 Stainless Steel Hawse Fittings: Ten (10) port and starboard 5" x 10" (12.7 cm x 25.4 cm) with cleats. Recessed into bulwarks where possible.

Two (2) 316 Stainless Steel Bollards port and starboard of windlass

Upper Rub Rail Cap to be 316 stainless steel 2-1/2" W x 7/16" thick (6.35 cm W x 1.1 cm thick) fastened with flush 316 stainless steel fasteners. Stainless steel caps on upper and lower rub rails

Lower Rub Rail Cap to be 316 stainless steel 1-1/2" W x 5/16" thick (3.81 cm W x 1.1 mm thick)

Manship Ports in Hull and Deck. Ports positioned as follows

Eight (8) starboard side hull 10" x 20" (25.4 cm x 50.8 cm) rectangular (all openning)

Nine (9) port side of hull 10" x 20" (25.4cm x 50.8 cm) rectangular (all openning)

Windows in Owner's Cabin

Glass to be 3/4" thick tempered safety with "fritted" edges for glue in installation per Silka Flex

Recesses to be vertical

Foredeck to have solid 316 stainless rail with 1-1/4" (3.18 cm) diameter stanchions. Bases to be round with fastening stud welded on bottom. All bases to have drain holes on bottom

Windshield Wipers: "Exalto" two (2) speed self-parking motor, with wash system for five (5) front windows

#EX2167.32 wiper motor 223BS 24 volt/23Nm, for 1- 3/8” (34.5 mm) bulkheads x five (5)

#EX2133 T1 Pantograph arm 10.6" (26.9 cm) - 17.7" (45 cm) adjustable x five (5)

#EX2171 curved wiper blade 16" (40.6 cm) x five (5)

#EX2159 Combo switch for single wiper 24 volt x five (5)

#EX2143 24 voltolt solenoid valve for wash system x one (1)

#EX2133.03 tubing retainer strip x five (5)

#EX2184 Washing Jet for type 1 adjustable pantograph arm x five (5)

#EX2186 plastic bulkhead connector for 19.7" (50 cm) - new style

#EX2154 Tubing 1/4” (6.35 mm) soft black x 5 meters

#EX2157 Tubing 1/4” (6.35 mm) hard black for push fit plumbing fittings x 5 meters

#EX2129 elbow .24" (6 mm) x six (6)

#EX2166 T-coupling 6x6x6mm (.24x.24x.24") x four (4)

#EX2119 straight coupling , 1/4” (6.35 mm) x one (1)

Horn: Kahlenberg dual trumpet #D-1 with chrome finish

Deck Hatches: Per deck plan, two (2) Lewmar #60 "Ocean Series" to include Oceanaire insect and privacy screens. Two Lewmar #20 "Ocean Series" to include Oceanaire insect and privacy screensover captain's cabin.

Access to Flybridge from Wheel House thru hinged cockpit hatch custom built by PCM

Windows by Pacific Coast Marine with 1/2” (1.27 cm) thick laminated tempered glass

All side windows to be tinted glass

Wheel house opening windows x three (3) to be PCM with insect screens

All salon windows are recessed 1" (2.5 cm)

Galley windows opening PCM

Aft wheel house corner windows to be 1/2" (1.27 cm) tempered safety glass

Aluminum doors by Pacific Coast Marine as follows (Note: interior as well as exterior PCM doors are included in this schedule)

Wheel house - Two (2) ea Weather Tight Dutch door, one (1) L.H. Mortise hinge, one (1) R.H. Mortise hinge. C.O. 21" x 73" (53.3 cm x 185.4 cm)

Salon after - One (1) ea, Weather Tight Sliding door. 60" x 73" (152.4 cm x 185.4 cm)

Salon port and starboard side - Two (2) ea, Weather Tight Dutch door, R.H. Mortise hinge. C.O. 21" x 73" (53.3 cm x 185.4 cm)

Engine room - Two (2) ea, Water Tight model no. PCM4170-W with sound blanket core, painted. L.H. surface mount hinge. C.O. 21" x 73" (53.3 cm x 185.4 cm)

Centerline Transom door to be pantograph style water tight painted to match hull color

Flybridge access

Boarding Doors: port and starboard plus two transom gates port and stbd.

Davit Marquipt 2500 lb (1134 kg) capacity hydraulic/240 volt AC with extendable boom to 18 feet (5.5 m) mounted on fore deck. Davit sized and positioned to launch dinghies from port and starboard side

Aft Deck Exterior Cabinet

Sink: Stainless steel to drain directly overboard

Faucet: Shurflo #133-0210-CP

Control alcove for engine control ABT bow and stern thruster jog levers, rudder angle indicator and steering jog, start/stop, air horn push buttons and forward windlass control

Bottom Treatment: Three (3) layers of epoxy barrier coat and three (3) coats of anti fouling paint

Two (2) coats of antifouling to be applied at Ta Shing and one (1) coat to be applied after the boat is hauled out at Kaohsiung before shipment

Anchor Well to Drain through scupper 2" (5.08 cm) diameter

All Exterior Lockers to have FRP louvers

FRP Radar Mast with flag halyards port and starboard.

Flybridge with FRP Hardtop, sink, U-Line #CO2175FFS drinks refrigerator with FRP door, and two (2) Stidd "Slimline" helm chairs #500n-2x2 white vinyl and settee with "Sunbrella" cushions and high gloss teak table with stainless steel pedestal and base. Ritchie #SS 5000 compass installed

FRP hardtop finished with smooth Gelcoat, with white painted on non-skid

Access to top of hard top via ladder TBD

Flybridge to drain via Six (6) 2" dia. Scupper drains

BBQ and Stainless steel sink

Granite bar top with three custom stainless steel bar stools

Jacuzzi 3 person spa Model # TBD

Stainless venturi with tinted acrylic panels per profile drawing

Stern Capstan Winches: Two (2) Maxwell VC 2200 24 volt port and starboard

Teak Flag Staff 48" (121.9 cm) with socket for aft rail

Freeman Watertight Deck Hatch over chain locker, #18HAALR

Anchor: 300 lb. (136 kg) stainless steel pool style with stainless steel anchor pockets custom built x two (2)

800 ft. 1/2" HT Chain (243.8 m 1.27 cm) in two (2) 400 ft. (121.9 cm) lengths from port and starboard chain lockers

Swim Ladder: Stainless steel built into "U" rail on centerline

Cleats - Two (2) Pop-up Style 10" (25.4 cm) Cleats on swim step port and starboard for dinghy tie up

Windlass: Maxwell VWC 4500 hydraulic with band brake and 1/2" HT (1.27 cm) chain gypsy x two (2)

Maxwell "RST" Chain Roller Stopper Tensioner for 1/2" (1.27 cm) diameter HT chain x two (2)

All Exterior Locker Doors to use "Perko" fig. 777 flush hatch dogs as latch

FRP Louvered Vents on all exterior locker doors

All Exterior Door Keepers to be ABI #2039CH

Large Pad Eye at stem through boot top 1-1/4" (3.2 cm) O.D integral to anchor pocket

Life Raft Pads port and starboard side of upper deck

Four (4) "U" Shaped Rails across swim step

Nordhavn Name Plates x two (2) port and starboard side

All Deck Washes to be installed in recessed FRP boxes with FRP doors

Zincs

Ship loose two (2) left hand shaft zincs and two (2) right hand shaft zincs

Ship Loose four (4) B4 plate zincs